According to a statistics gathered by the Centers for Disease Control (CDC), automatic nailers or nail guns are responsible for nearly 40,000 ER visits every year. But the risk is not limited to construction workers. The CDC found that almost a third (32%) of annual nail gun injuries are sustained by consumers.

Nail guns are generally one of two types: contact nail guns or sequential nail guns. With a contact nail gun, there’s a spring loaded safety mechanism at the tip of the “barrel.” You can hold down the trigger and the gun will automatically fire when you make contact with something, as it will disengage the safety mechanism. With a sequential gun, you must first depress the safety mechanism and then pull the trigger. If you have already pulled the trigger and try to depress the safety mechanism, it won’t work. Not surprisingly, the CDC found twice as many injuries involving contact guns.

The Principal Causes of Nail Gun Injuries

Researchers found a number of causes of nail gun injuries:

  • Unfortunately, in many instances, people are hurt because they have bypassed or permanently disengaged the safety mechanisms
  • It’s not uncommon for a gun to double fire, with the second nail coming out after the gun has been pulled away from the board
  • A nail can ricochet off a metal surface or even a knot in a board
  • A framing nail can easily penetrate a stud, causing injury if a worker’s hand is on the back side of the board
  • A worker may accidentally push the gun against a leg, hand or other body part
  • A worker may miss the board, even though the safety mechanism has been depressed

Contact the Law Office of Taylor & Boguski

At Taylor & Boguski, we bring more than 70 years of combined legal experience to injured people throughout New Jersey. For a free initial consultation, contact us online or call us at 856-200-8989.

Seven construction workers were injured in a Hackensack scaffolding collapse in early December—three critically. Authorities say the workers were performing repairs on the roof of an apartment complex on Tracy Place around 3:30 in the afternoon when the scaffolding fell. There were six workers on the scaffold at the time it collapsed. The workers fell approximately 45 feet to the ground.

The accident occurred at an apartment complex known as ‘The Brookdale’, which has approximately 200 apartments in 10 buildings.

According to witnesses, the scaffold was a makeshift one. One neighbor, who declined to be identified, said that it wasn’t “a real scaffolding,” but was “jerry-rigged” together with ladders and planks. The neighbor said the way the system was set up, it did not seem reasonable that it could support the weight of all the workers. Authorities confirmed that no permit had been pulled to do the work on the roof. Both OSHA and the Bergen County Sheriff’s Bureau of Criminal Identification reportedly came to the site for an investigation.

Under state and federal laws and regulations, building owners and general contractors have to take certain steps to minimize the risk of injury to workers. Specifically, when workers are employed at levels above the ground, they must be provided with adequate safety equipment, which may include:

  • Properly installed scaffolding
  • Safety harnesses or hoists
  • Well-maintained and sufficient ladders

Witnesses said that the “scaffold” setup at the apartment complex consisted of so-called “ladder jacks” holding walk-boards between two extension ladders. Preliminary investigations indicated that there were no rails on the scaffolding, and that the workers did not have safety harnesses or similar devices. Authorities believe that the workers, who were unsupervised at the time, exceeded the weight limit of the walkboard.

Contact a Workers’ Compensation Lawyer Today

At Taylor & Boguski, we bring more than 70 years of combined legal experience to injured people – including workplace accidents and construction accidents – throughout New Jersey. For a free initial consultation, contact our office online or call us at 856-200-8989.